Chicago Electric 30858 Manuel d'utilisateur télécharger pdf (Page 8)

SKU 30858 For technical questions please call 1-800-444-3353. Page 8

Double Insulated

Canadian Standards

Association

Underwriters

Laboratories, Inc.

V ~

Volts Alternating Current

Amperes

xxxx/min.

No Load Revolutions

Per Minute (RPM)

SYMBOLOGY

WARNING! The warnings, precautions, and instructions discussed in this manual cannot

cover all possible conditions and situations that may occur. The operator must understand

that common sense and caution are factors which cannot be built into this product, but

must be supplied by the operator.

Unpacking

When unpacking the Halogen Floor Shop Light, check to make sure parts on page 10 are included.

If any parts are missing or broken, please call HARBOR FREIGHT TOOLS at 1-800-444-3353.

Assembly

Your Halogen Floor Shop Light will require some minor assembly. The Light requires special

conditions for set up and operation. It is important that you read the entire manual to become

familiar with the product BEFORE you use the Light.

1. Slide the Halogen Lamp onto the Steel Stand (4). Place the Mounting Bracket on the Light

onto the Steel Stand (4) and thread in the Knob (1).

2. Loosen the Knob (1) to pivot the Light. The Light Pivots 180 degrees up and down. To pivot

the Light, move it by the Handle at the top of the Steel Stand. NEVER touch the Halogen

Light to move it or pivot it.

Bulb Replacement

1. Make certain that the product is OFF and unplugged. With leather gloves on, squeeze and

remove the Grid from the front of the Light.

2. Remove the Bolt from the top of the Light.

3. Pull out the Lens from the front of the Light.

4. Make certain that the Halogen Bulb (3) has had sufﬁcient time to cool. Gently pull out the

Halogen Bulb.

1 2 3 4 5 6 7 8 9 10

Pas de commentaire

Chicago Electric 30858 Manuel d'utilisateur Page 8